HD Install :: Partitioning nightmare

What type of hd-install did you use?

Try `rmmod via-rhine` then `modprobe via-rhine` then run `netcardconfig`.

Note that the MyDSL browser relies on the internet being active.

The hdinstall I selected was LILO.

When I go to the DSL ATerminal:

rmmod via-rhine
I get the response:
module via-rhine is not loaded

modprobe via-rhine
I get the response:
/lib/modules/2.4.26/kernel/drivers/net/b44.o: init-module: no such device
Hint: insmode errors can be caused by incorrect module parameters, including invalid IO or IRQ parameters.
You may find more information in syslog or the output from dmesg
/lib/modules/2.4.26/kernel/drivers/net/b44.o: insmod /lib/modules/2.4.26/kernel/drivers/net/b44.o: failed
/lib/modules/2.4.26/kernel/drivers/net/b44.o: insmod via-rhine failed

netcard config
I get the response:
bash: netcard: command not found

A frugal lilo?

Which version of DSL are you using? I think there was a changeup in the b44 module.

Note that "netcardconfig" is one word, and that it can't be used it if the module does not load.

Quote (^thehatsrule^ @ Mar. 11 2007,12:22)

A frugal lilo?

Which version of DSL are you using? I think there was a changeup in the b44 module.

Note that "netcardconfig" is one word, and that it can't be used it if the module does not load.

Quote

A frugal lilo?

yes

Quote

Which version of DSL are you using?

guess it's DSL 3.2

Check "System Stats" for the version.

For now I think you can try a 3.3 RC or 3.0 ... can't remember which one's exactly.

Next Page...
original here.